Cash Acceptor
Cleaning Sensors
NCR Personas M Series 5887 Operator Manual 11-27
Reject Unit - Cleaning
Lever
11
To clean the sensors in the reject unit area, push in the cleaning lever
three or four times, as indicated below.
Completing the Sensor
Cleaning Procedures
11
To complete the process after cleaning the sensors, proceed as
follows:
1 Ensure all units and doors are pushed back into their home
positions.
2 Push the cash acceptor back into the terminal until it clicks into
place.
3 Follow your in-house procedures for indicating that the sensors
have been cleaned.
4 If your terminal does not have the auto-supervisor option, press
the switch on the operator panel to the normal position.
5 Close and lock the exterior of the terminal.
To Next Page
Loading...
