NCR RealPOS User Manual

5-70 Chapter 5: Programming
Code 128 Minimum and Maximum Tag Length
24954
Selection Programming Tag Sequence
v = 1-3 (default is 3)
w = 1-9 (default is 9)
x = 1-3 (default is 3)
y = 1-9 (default is 9)
Scan Default Tag
Length Programming Mode, Hex 7, Hex 2, a, v, w, x, y, Save and Reset
where a = Ø (Range of lengths) or 1 (Specific Length)
Default
Code 128 Stitch
24386
Selection Programming Tag Sequence
Disable Programming Mode, Hex 7, Hex 0, Hex 9, Hex C, Save and Reset
Enable Programming Mode, Hex 7, Hex 0, Hex 9, Hex D, Save and Reset
Code 39 Tone Length
24385
Selection Programming Tag Sequence
Programming Mode, Hex 7, Hex 0, Hex 3, Hex 2, Save and Reset30 ms
45 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex 3, Save and Reset
60 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex 4, Save and Reset
75 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex 5, Save and Reset
150 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex A, Save and Reset
180 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex C, Save and Reset
195 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex D, Save and Reset
165 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex B, Save and Reset
0 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex 0, Save and Reset
15 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex 1, Save and Reset
90 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex 6, Save and Reset
105 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex 7, Save and Reset
120 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex 8, Save and Reset
135 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex 9, Save and Reset
210 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex E, Save and Reset
225 ms Programming Mode, Hex 7, Hex 0, Hex 3, Hex F, Save and Reset

NCR RealPOS Specifications

General

Scanning Technology	Laser
Interface	RS-232, USB
Supported Barcodes	UPC/EAN, Code 39, Code 128, Interleaved 2 of 5, Codabar, MSI, Code 93
Storage Temperature	-40° to 70° C (-40° to 158° F)
Humidity	5% to 95% (non-condensing)