NCR RealPOS - Codabar Halves; Codabar Stitch; Codabar Require Start;Stop Match; Codabar Require Quiet Zones

Chapter 5: Programming 5-79
Codabar Halves
25325
Selection Programming Tag Sequence
Programming Mode, Hex 7, Hex 4, Hex 5, Hex 3, Save and Reset
Disable Programming Mode, Hex 7, Hex 4, Hex 5, Hex 2, Save and Reset
Enable
Setting
Default
Codabar Stitch
25513
Selection Programming Tag Sequence
Programming Mode, Hex 7, Hex 4, Hex 5, Hex 5, Save and Reset
Disable Programming Mode, Hex 7, Hex 4, Hex 5, Hex 4, Save and Reset
Enable
Setting
Default
Codabar Require Start/Stop Match
25320
Selection Programming Tag Sequence
Programming Mode, Hex 6, Hex B, Hex 2, Hex 1, Save and Reset
Disable Programming Mode, Hex 6, Hex B, Hex 2, Hex 0, Save and Reset
Enable
Setting
Default
Codabar Require Quiet Zones
25321
Selection Programming Tag Sequence
Programming Mode, Hex 6, Hex B, Hex 2, Hex 3, Save and Reset
Disable Programming Mode, Hex 6, Hex B, Hex 2, Hex 2, Save and Reset
Enable
Setting
Default
Note: Ensure that this sequence is set to Enable if Codabar is programmed to read
very short tags (tags with less than 4 data characters). This programmable
prevents getting a very short Codabar tag from another barcode type or from
package graphics.
Codabar Start/Stop Transmission
25322
25327
Selection Programming Tag Sequence
Programming Mode, Hex 6, Hex B, Hex 1, Hex 2, Save and Resettn*e
TN*e Programming Mode, Hex 6, Hex B, Hex 1, Hex 3, Save and Reset
abcd Programming Mode, Hex 6, Hex B, Hex 1, Hex 0, Save and Reset
ABCD Programming Mode, Hex 6, Hex B, Hex 1, Hex 1, Save and Reset
Setting
Default