NCR RealPOS - Scans Required on GS1 Databar-14; Scans Required on GS1 Databar-E; UCC-128 Emulation Mode

Chapter 5: Programming 5-37
GS1 DataBar Enable
This parameter contains 4 selections. Disable reading GS1 DataBar bar codes by scanning the
Hex 0 programming tag.

Reading either or both GS1 DataBar–14 and GS1 DataBar–E bar codes is enabled with
this parameter.

Read GS1 DataBar–14 only—Scan the Hex 1 programming tag

Read GS1 DataBar–E only—Scan the Hex 2 programming tag

Read both GS1 DataBar–14 and GS1 DataBar–E—Scan the Hex 3 programming tag
Scans Required on GS1 DataBar–14
This parameter sets the number of scans required to read a GS1 DataBar–14 bar code.
Increasing the number of scans can improve reading nominal bar codes. There are four
settings: 1 scan, 2 scans, 3 scans, and 4 scans. Set this parameter by scanning the appropriate
programming tag, Hex 1 through Hex 4.
Scans Required on GS1 DataBar–E
This parameter sets the number of scans required to read a GS1 DataBar–E bar code.
Increasing the number of scans can improve reading nominal bar codes. There are four
settings: 1 scan, 2 scans, 3 scans, and 4 scans. Set this parameter by scanning the appropriate
programming tag, Hex 1 through Hex 4.
UCC–128 Emulation Mode
The UCC–128 Emulation Mode refers to the Uniform Code Council Code 128 Data Formatted
Start Code. Two choices are available for this parameter. Scan the Hex 0 programming tag for
normal mode or the Hex 1 programming tag to enable UCC–128 Emulation.