NCR RealPOS - Bar Codes-7; Pharmacode Check Digit Transmission

5-42 Chapter 5: Programming
Bar Codes–7
25516
Pharmacode
2
Disable
3
Enable
Pharmacode
Check Digit
Transmission
5
Disable
4
Enable
Your Program
Bar Codes - 7
7 F
The Bar Codes 7 programming mode contains programming parameters for Pharmacode bar
codes. Refer to the “Parameter Defaults” section earlier in this chapter for the factory defined
default value of each programming parameter.
Pharmacode Check Digit Transmission
The Pharmacode Check Digit Transmission parameter selects whether to send the check digit
to the host terminal. Scan the Hex 0 tag to disable this option, or the Hex 1 tag to enable this
option.