NCR RealPOS User Manual

Chapter 5: Programming 5-83
Command–type Disable
24959
Selection Programming Tag Sequence
Programming Mode, Hex 6, Hex 7, Hex 9, Save and Reset
Disable Programming Mode, Hex 6, Hex 7, Hex 8, Save and Reset
Enable
Setting
Default
Ignore RS-232 Commands from Host Terminal
24960
Selection Programming Tag Sequence
Programming Mode, Hex 7, Hex 0, Hex A, Hex 1
Disable Programming Mode, Hex 7, Hex 0, Hex A, Hex 0
Enable
Default
Setting
Enable UPC NS5 Coupon
24964
Selection Programming Tag Sequence
Programming Mode, Hex 7, Hex 1, Hex D, Save and Reset
Enable Programming Mode, Hex 7, Hex 1, Hex C, Save and Reset
Disable
Setting
Default
GS1 DataBar AI 8110 coupons
GS1 DataBar 8110
27800
Selection Programming Tag Sequence
Programming Mode, Hex 7, Hex 1, Hex 1, Save and Reset
Disable Programming Mode, Hex 7, Hex 1, Hex 0, Save and Reset
Enable
Setting
Default
GS1 DataBar–E AI 8110
27801
Selection Programming Tag Sequence
Programming Mode, Hex 7, Hex 1, Hex3, Save and Reset
Disable Programming Mode, Hex 7, Hex 1, Hex2, Save and Reset
Enable
Setting
Default
EAN–13 98 coupons
24967
Selection Programming Tag Sequence
Programming Mode, Hex 7, Hex 1, Hex 9, Save and Reset
Enable Programming Mode, Hex 7, Hex 1, Hex 8, Save and Reset
Disable
Setting
Default

NCR RealPOS Specifications

General

Scanning Technology	Laser
Interface	RS-232, USB
Supported Barcodes	UPC/EAN, Code 39, Code 128, Interleaved 2 of 5, Codabar, MSI, Code 93
Storage Temperature	-40° to 70° C (-40° to 158° F)
Humidity	5% to 95% (non-condensing)