NCR RealPOS - Bar Codes-3; Interleaved 2 of 5

Chapter 5: Programming 5-31
Bar Codes–3
25788
A
B
Interleaved
2 of 5
Bar Code
Length
C
Check Digit
Present
D
1
0
Disable
Enable
0 - 3
1
0
Range
Check
Specific
Check
Character
Minimum
Character
Maximum
1
0
Disable
Enable
1
0
Disable Enable
0 - 3
0 - 9
0 - 9
Transmit
Check Digit
Character 1
Character 2
Character 1
Character 2
Default
Default
1
6
08
Value 1
Value 2
Your Program
A
Interleaved
2 of 5
Bar Codes - 3
1 5
Check Digit
Present
C
Transmit
Check Digit
D
Value 1 Value 2Bar Code
Length
B
E
1
0
Disable Enable
Easy I25
Note: Requires only 1 scan.
The Bar Codes 3 programming mode contains programming parameters for Interleaved 2 of 5
(“ITF” or “I 2 of 5”). Refer to the “Parameter Defaults” section earlier in this chapter for the
factory defined default value of each programming parameter.
Interleaved 2 of 5
The Interleaved 2 of 5 parameter controls reading Interleaved 2 of 5 bar codes. Disable reading
Interleaved 2 of 5 bar codes by scanning the Hex 0 tag and enable reading by scanning the Hex
1 tag.
Note: If reading Interleaved 2 of 5 bar codes is disabled, there are no other entries allowed
for this parameter.