Chapter 5: Programming 5-9
HEX 0–HEX F
Function
These sixteen (16) tags enter the selections for each of the parameters in the Parameter
Programs. They also select the Parameter Program
Indication
Hex 0—Scanner says “Zero” with no beeps. If voice disabled, scanner produces a short
beep, different frequency from Good Read tone.
Hex 1 through Hex F—Scanner says “<tag value>” with no beeps. If voice is disabled,
the scanner produces a number of beeps according to the tag value. Multiples of 4 short
beeps grouped together.
Example: Hex D Scanner says “D”. If voice is disabled, Hex D is indicated by 12 short
beeps (3 sets of 4) followed by 1 beep, for a total of 13.
PROGRAM MODE
Function
This tag sets the 7893 into Program Mode. It must be the first tag scanned after applying power
to the 7893, or after scanning the Default tag or the Reset tag.
Indication
LED Status indicator is initially dim green and then flashes bright green showing the tag
was read.
The scanner says “Program Mode” with no beeps.
If Voice NOT enabled, Short beep, long beep, short beep—indicates Program Mode
SAVE AND RESET
Function
This tag instructs the 7893 to save and start using the programming data. It is used in the
Program Mode.
Indication
LED Status Indicator flashes red twice, then scanner reboots and performs power up
sequence (the LED Status Indicator turns off momentarily, then comes on with bright blue
LED followed by a gradual change to bright green, then back to normal state at dim green).
Short beep as soon as tag is read—Good Read tone
Motor stops momentarily while scanner reboots, then they come up to full speed.
One beep when the scanner has completed power cycling.
Reboots with no voice.
To Next Page
Loading...
