Chapter 5: Programming 5-27
Bar Codes–2
Code 39
A
0
Disable
1
Enable
Minimum
Characters
Allowed
B
8
2 - F
Default
Full ASCII
C
0
Disable
1
Enable
Check Digit
Present
D
0
Disable
1
Enable
Transmit
Check Digit
E
0
Disable
1
Enable
Allow 1- or
2-Character
Tags
F
0
Disable
1
Enable
Your Program
24174
Code 39
A
Bar Codes - 2
1 4
Minimum
Characters
Allowed
B
Full
ASCII
C
Check Digit
Present
D
Transmit
Check Digit
E
Allow 1-
or
2-Character
Tags
F
For SuperASIC scanners,
continue to option F even if
Check Digit Present Disable
is chosen.
Note:
The Bar Codes 2 programming mode contains programming parameters for Code 39. Refer to
the “Parameter Defaults” section earlier in this chapter for the factory defined default value of
each programming parameter.
Code 39
The Code 39 parameter controls reading Code 39 (“3 of 9”) bar codes. Disable reading Code
39 bar codes by scanning the Hex 0 tag and enable reading by scanning the Hex 1 tag.
If reading Code 39 bar codes is disabled, there are no other entries permitted for this
parameter.
To Next Page
Loading...
Need help?
General
