NEC Storage M100 Series - Page 106

Release 6.0 106
User Guide Chapter 4 NEC Storage Manager
4.3.1.2 For Linux
Follow the steps below to install Network Setting Tool.
For the M10 and M100 series disk arrays, use the NEC Storage Manager Express Setup and Utility
CD-ROM that comes with the disk array. For the M300 series disk arrays, it is necessary to prepare
NEC Storage BaseProduct.
1. Log in as root user.
2. Set the CD-ROM in the CD-ROM drive of the client.
If you cannot use the CD-ROM in your environment, send the iSMnetconfig.rpm file from another
server.
3. Mount the CD-ROM
 Create a mount directory (Example: /cdrom)
mkdir /cdrom
 Use the mount command.
mount -r /dev/cdrom /cdrom
4. Install JRE.
 Copy the installer to a directory you want to use (for example, /tmp).
cp -r /cdrom/JRE/LINUX/jre-6u21-linux-i586-rpm.bin /tmp/.
 Run the installer you have copied.
/tmp/jre-6u21-linux-i586-rpm.bin
5. Use the rpm command for the installation.
rpm -ivh /cdrom/NETCONFIG/LINUX/iSMnetconfig.rpm
6. The following message is shown when the installation is complete.
7. Unmount the CD-ROM. Use the unmount command.
umount /cdrom
8. Register JRE with the Web browser (Firefox) according to the following procedure.
a. Exit Firefox.
b. If any JREs have been registered with the plugins directory of Firefox, delete them. (You cannot
register JRE of different versions at a time.)
Remove the symbolic links "libjavaplugin-oji.so" and "libnpjp2.so" from
/usr/lib/firefox-<version>/plugins (for the default settings).
If it is already installed on your machine, the installation is not necessary.
Installation of iSMnetconfig was successful.