NEC Storage M100 Series - Figure 3-3: Rail; Figure 3-4: Attaching Rail to Rear Pole

Release 6.0 70
User Guide Chapter 3 Installing the Disk Array System
1. Check the rail (L)
The side with the inner is rear.
The rail (L) looks L-shaped when it is seen from the front side.
Attach the rail to the left side of the rack which is seen from its front side.
Figure 3-3: Rail
2. Align both sides of the bottom of the rail with the 1U delimiting marks on the rear pole of the rack
and then let the two projections on the inner into the holes on the pole.
Figure 3-4: Attaching Rail to Rear Pole