NEC Storage M100 Series - H.2 Checking Connection from Application Server

Release 6.0 417
User Guide Appendix H How to Set/Check Application Server (VMware) (iSCSI)
H.2 Checking Connection from Application Server
Perform the following steps to connect the application server and disk array unit in a VMware
environment.
After executing a rescan, make sure that a list of
available adapters is shown by the software iSCSI
Initiator used to access software- activated iSCSI
storage disk array units.
For details, refer to Section H.2.1: Executing Rescan.
Set up a data store for the software-activated iSCSI
storage device.
For details, refer to Section H.2.2: Setting up a Data
Store.
Make sure that the logical disks are recognized by the
Guest OS.
For details, refer to Section H.2.3: Confirmation Using
Guest OS.