NEC Storage M100 Series - Figure 1-13: LED Display - Disk Array Enclosure Adapter; Table 1-10: Status Display LED; Table 1-11: Disk Port Status

Release 6.0 52
User Guide Chapter 1 Overview
1.2.3.4 Adapter (ADP)
Figure 1-13: LED Display - Disk Array Enclosure Adapter
Table 1-10: Status Display LED
(1) Ready
LED
(2) Fault LED (3) ID LED
StatusGreen Orange Blue
Not lit Not lit - Not connected or, not powered on.
Flashing Not lit -
Running successfully.
Flashing Flashing in a
cycle of 0.5
second
- Initializing firmware.
Flashing Flashing in a
cycle of 1
second
- Error between adapters has been detected.
Flashing Lit - Error in the adapter has been detected. (Operation
continued).
Not lit Lit - Error in the adapter has been detected. (Unable to
continue operation).
- - Lit The device is selected.
Table 1-11: Disk Port Status
Disk port Status
(4) Link LED (LNK) (Green) Lit = linkup
Not lit = link down
(5) Fault LED (FLT) (Orange) Lit = An error is detected
Not lit= Normal