Release 6.0 402
Appendix H How to Set/Check Application Server
(VMware) (iSCSI)
This appendix provides the steps you should follow while setting or checking an application server in the
VMware environment, when the disk array is configured for the iSCSI connection.
H.1 Initializing Application Server
Perform the following steps to initialize the application server in the VMware environment.
The following describes the steps for using software iSCSI Initiator in the ESX Server
environment.
Prepare for installation.
For details, refer to Section H.1.1: Preparation.
Create a VMKernel port and connect iSCSI to the
network.
For ESX Server 3, connect the service console to the
iSCSI network.
For details, refer to Section H.1.2: Creating VMKernel
Port.
Set the iSCSI Software Initiator as active, and then set
the target address of the Initiator. If necessary, enter
settings for CHAP authentication.
For details, refer to Section H.1.3: Setting up Software
iSCSI Initiator.
To Next Page
Loading...
