NEC Storage M100 Series - Figure 3-5: Screwing Rail on Front Pole; Figure 3-6: Attaching Rail to Rear Pole

Release 6.0 71
User Guide Chapter 3 Installing the Disk Array System
3. Align both side of the bottom of the rail with the 1U delimiting marks on the front pole of the rack and
let the two projections on the rail into the holes on the pole.
There are two types of rack, rectangular-hole rack and circular-hole rack. Each of them has a
different type of projection on the rail.
Insert M5 screws into the two central screw holes on the front pole of the rack to screw the rail.
Figure 3-5: Screwing Rail on Front Pole
4. Move the inner towards the rear pole of the rack and let the two projections in the holes on the pole.
Figure 3-6: Attaching Rail to Rear Pole