Release 6.0 210
User Guide Chapter 7 Initializing a Disk Array (SAS)
2. Collecting host information by using files reported by the host information collection
command
When a disk array is installed in a system that has already begun operating, use the host
information collection command to report files. Registering the reported files allows assigning the
application server to created logical disks. For details about how to register reported files, see
Section E.2.2: “Registering Host Information by Using File Output”.
Figure 7-2: Configuration - Collect Host Information Using Host Information Collection
Command
7.2.1 Collecting Host Information From Application Server
To make settings for collecting host information automatically or through a disk array, see Section
7.3.5: “Collecting Host Information”.
For details about how to collect host information, see one of the following depending on the platform of
the application server:
For a Linux application server, see Section E.2: “Collecting/Registering Host Information on
Application Server”.
To Next Page
Loading...
