NEC Storage M100 Series - Setting a Time Zone of the Disk Array; Figure 4-19: Select Disk Array Type

Release 6.0 114
User Guide Chapter 4 NEC Storage Manager
4.3.3 Setting a Time Zone of the Disk Array
This section describes how to set a time zone of the disk array.
4.3.3.1 For Windows
Use NEC Storage Manager Setup to configure the time zone settings.
NEC Storage Manager Setup is automatically started when you set the NEC Storage Manager
Express Setup and Utility CD-ROM, and it allows you to perform the settings as prompted. Depending
on your environment, it may not start automatically, in which case, run the following program in the
CD-ROM.
\INSTALL\WINDOWS\ISMSETUP.EXE
Follow the steps below by using NEC Storage Manager Setup.
1. After you configure IP addresses as described in Section 4.3.2: “Configuring IP Addresses by Using
Network Setting Tool”, the page to set a time zone appears.
Figure 4-19: Select Disk Array Type