NEC Storage M100 Series - Figure H-15: General Properties Screen; Figure H-16: Dynamic Discovery Tab in Iscsi Initiator Properties Screen

Release 6.0 413
User Guide Appendix H How to Set/Check Application Server (VMware) (iSCSI)
5. Select the Enabled check box under Status in the General Properties screen. After completing the
settings, click the OK button.
Figure H-15: General Properties Screen
Set up detection address
Set the target detection address so that the software Initiator is able to designate access-enabled
storage resources on the network.
1. Click the Add button under the Dynamic Discovery tab in the iSCSI Initiator Properties screen.
Figure H-16: Dynamic Discovery Tab in iSCSI Initiator Properties Screen