Release 6.0 296
User Guide Chapter 10 Troubleshooting
10.7 Changing Network Settings for Monitoring Disk Arrays from Storage
Manager
If a disk array cannot be monitored correctly from Storage Manager due to faults occurring in
performing initialization or erroneous settings, network settings must be changed.
Change disk array network settings using any of the following two procedures.
Whether the disk array or management server must be changed is noted in the summary of each
setting. Make changes after taking into account their effect on business.
1. Changing Network Setting from Storage Manager
If the disk array is monitored from Storage Manager, the disk array unit network settings can be
changed from Storage Manager.
Make changes using [Configuration] - [Disk Array] - [Management Port Settings] from the menu. For
details, refer to the NEC Storage Software Configuration Setting Tool User's Manual (GUI) for the M
Series.
2. Changing Network Setting from Network Setting Tool
The disk array unit network settings can be changed from Network Setting Tool. For details, see
Section 4.3.2: “Configuring IP Addresses by Using Network Setting Tool”.
To Next Page
Loading...
