NEC Storage M100 Series - Figure 4-16: Select a Disk Array; Table 4-3: Initialization Status of Disk Array

Release 6.0 110
User Guide Chapter 4 NEC Storage Manager
2. Click Refresh when Network Setting Tool is started.
Figure 4-16: Select a Disk Array
Disk arrays detected through search are displayed.
“not set” is shown for Status for disk arrays for which network settings will be performed for the first
time.
3. Select the target disk array from the list and click Set.
If the M series has been installed and IP addresses have been configured, "finished" is shown in the
Status column. For details about information shown for the Status column, see Table 4-3.
Table 4-3: Initialization Status of Disk Array
Status Description
Displayed information Disk array status
not set Disk array has just been installed
The disk array is not monitored by NEC Storage Manager
because the network settings have not been done.
IP addresses must be configured by using Network Setting Tool
finished IP addresses have been configured
The disk array can be monitored by NEC Storage Manager.