Release 6.0 129
User Guide Chapter 5 Initializing a Disk Array (FC)
2. Collecting host information by using files reported by the host information collection
command
When a disk array is installed in a system that has already begun operating or any of the application
servers to be connected by FC cables is on an OS other than Windows or Linux (RHEL5 or later or
SLES10 or later), use the host information collection command to report files. Registering the
reported files allows assigning the application server to created logical disks. For details about how
to register reported files, see Section B.2.2: “Registering Host Information by Using File Output” for
a Windows environment, or Section E.2.2: “Registering Host Information by Using File Output” for a
Linux environment.
Figure 5-2: Configuration - Collect Host Information Using Host Information Collection
Command
5.2.1 Collecting Host Information From Application Server
To make settings for collecting host information automatically or through a disk array, see Section
5.3.5: “Collecting Host Information”.
For details about how to collect host information, see one of the following depending on the platform of
the application server:
For a Windows application server, see Section B.2: “Collecting/Registering Host Information on
Application Server”.
For a Linux application server, see Section E.2: “Collecting/Registering Host Information on
Application Server”.
To Next Page
Loading...
