Release 6.0 329
User Guide Appendix C How to Set/Check Application Server (Windows) (iSCSI)
C.1.4 Setting up iSCSI Software Initiator
Settings for the Windows Server 2008 environment are described below.
1. Select the General tab in the iSCSI Initiator Properties screen to check the iqn (iSCSI Qualified
Name) shown as the Initiator name.
Figure C-12: iSCSI Initiator Properties (General Tab) Screen
Click the Change button to change the iqn.
Click the Secret button when using the mutual CHAP authentication.
Click the Setup button when using the IPSec tunnel mode function. This is not supported.
The Secret setting for mutual CHAP authentication must also be set for
the disk array unit. The setting method is described in Section 15.3.21:
iSMcfg setldsetchap of NEC Storage Manager Command Reference.
Mutual CHAP authentication is also described in NEC Storage Manager
Command Reference as Bidirectional CHAP authentication.
CHAP authentication is also described in Appendix N: "Retrieve Initiator Information on
Application Servers Registered with iSNS Server".
To Next Page
Loading...
