NEC Storage M100 Series - Table 1-3: Standby LED (White); Table 1-4: Active;Fault LED (Green;Orange) of Disk Drive

Release 6.0 46
User Guide Chapter 1 Overview
Lit 1 second
Not lit 1 second
Lit
Firmware being updated online.
Not lit
Lit 0.2 seconds
Not lit 0.2 seconds
Auto flashing (*) has finished and power can be
turned off.
Not lit Not lit Powered off.
When access to a host connection port is disconnected for five minutes, transition to this
mode takes place automatically to be prepared for power-off. When access from the host
connection port is restored, ordinary status is restored.
Table 1-3: Standby LED (white)
(4) Standby LED Status
Not lit DC on and off operation is not available
Lit DC on and off operation is available
Table 1-4: Active/Fault LED (green/orange) of Disk Drive
(5) Active LED (6) Fault LED Status
Not lit Not lit Powered off.
Lit Not lit Ordinary (READY)
Flashing Not lit
Ordinary (in the course of ACCESS)
Flashing Flashing Recovered
Lit Flashing Hard disk drive save-energy mode
Lit Lit Failure
Table 1-2: Service LED/Power LED (orange/green) (Contd.)
(2) Service LED (3) Power LED Meaning