NEC Storage M100 Series - Figure 1-6: Power Supply

Release 6.0 38
User Guide Chapter 1 Overview
1.2.1.3 Power Supply
Figure 1-6: Power Supply
Label Description
(1) Power plug Use the power cable shipped together with the disk
array for supplying power to the disk array.
(2) Power cable clamp The power cable clamp prevents the power cable
from coming off unintentionally.
(3) Ejector The ejector is used to install and remove a power
supply.
(4) AC switch The AC switch is used to power on and off input of
power supply.
(5) Input Good LED (green) This LED is lit if power is supplied when the AC
switch is turned on.
(6) Fault LED (orange) This LED is lit when an error is detected.