Release 6.0 356
User Guide Appendix D How to Set/Check Application Server (Windows) (iSCSI HW Initiator)
D.1.2 Preparation
1. Provide IP addresses for an application server
Prepare IP addresses to be assigned to the application server as many as the connection ports. In
addition, prepare the subnet mask and gateway addresses by asking the network administrator.
2. Connect to the disk array unit
Use a 10-Gbps cable to connect the application server to the host port (HP connector) of the disk
array unit.
For a sample connection configuration, see Appendix L: iSCSI Connection
Configuration-Examples.
For the positions of the host ports, see “(5) Connect to the disk array unit” of Section C.1.1:
Preparation.
NF9320-SJxx (FC cable) can be used.
To Next Page
Loading...
