Release 6.0 374
Appendix E How to Set/Check Application Server (Linux)
(FC/SAS)
This appendix provides the steps you should follow while setting or checking application server in the Linux
environment, when the disk array is configured for the FC connection.
E.1 Installing NEC Storage Manager Agent Utility
This section describes how to install the NEC Storage Manager Agent Utility.
E.1.1 Before Installation
Note the followings before installing the NEC Storage Manager Agent Utility. The following functions
become available by installing the NEC Storage Manager Agent Utility.
iSM volume list command
Host agent (Host agent service)
iSCSI Setup Tool
NEC Storage Host Register Agent
Table E-1shows the supported operating environment.
Table E-1: Operating Environment (Linux)
* Above are the supported environments for this version at the point of the initial shipment of this
product.
Operating systems Red Hat Enterprise Linux Version 5 (*1)
Red Hat Enterprise Linux 5.5 to 5.7 (IA32/EM64T)
Red Hat Enterprise Linux 5.5 to 5.7 Advanced Platform
(IA32/EM64T)
Red Hat Enterprise Linux Version 6
Red Hat Enterprise Linux 6.1 (IA32/EMT64)
SUSE Linux Enterprise Server10
SUSE Linux Enterprise 10 SP3 (IA32/EM64T) (*2)
(*1) The iSCSI Setup Tool (sharing function) supports Red Had Enterprise
Linux 5.5 (IA32, EM64T).
(*2) Only for disk arrays connected via FC
Memory OS required memory + 5 MB or more (IA32 server and EM64T server)
Disk capacity 12 MB or more
To Next Page
Loading...
