Release 6.0 385
Appendix F How to Set/Check Application Server (Linux)
(iSCSI)
This appendix provides the steps you should follow while setting or checking an application server in the Linux
environment, when the disk array is configured for the iSCSI connection.
F.1 Initializing Application Server
Perform the following steps to initialize the application server in Linux environment.
Prepare for installation.
For details, refer to Section F.1.1: Preparation.
Install the iSCSI-initiator-utils package.
For details, refer to Section F.1.2: Installing iSCSI
Software Initiator.
If the iSCSI-initiator-utils package has already been
installed, this step is not necessary.
Install PathManager.
For details, refer to Section F.1.3: Installing NEC
Storage PathManager.
When PathManager will not be used, this step is
not necessary.
This describes how to set up the Open-iSCSI driver
and CHAP authentication.
For details, refer to Section F.1.4: Setting up iSCSI
Software Initiator.
To Next Page
Loading...
