Release 6.0 393
User Guide Appendix F How to Set/Check Application Server (Linux) (iSCSI)
F.2 iSCSI Setup Tool
Run the iSCSI Setup Tool on an application server to configure the iSCSI settings required for the
application server. Before starting the following section, you need to install the NEC Storage Manager
Agent Utility. See Section D.1.1: Overview for details on how to install the NEC Storage Manager
Agent Utility.
1. Run the following script on the application server.
2. When a list of serial numbers is shown as follows, enter a list number corresponding to the serial
number of the disk array unit you want to configure.
3. The following message appears to confirm whether to use CHAP authentication. Enter y to use the
CHAP authentication. Enter n to skip the CHAP authentication.
4. When n is entered to skip the CHAP authentication, proceed to step (9). When y is entered to use
the CHAP authentication, the following message appears. Enter the password of the CHAP initiator.
5. To confirm, enter the password of the CHAP initiator again.
6. This is to confirm whether to use mutual CHAP authentication. Enter y to use the mutual CHAP
authentication. Enter n to skip the mutual CHAP authentication.
7. Proceed to step (9) when n is entered to skip the CHAP authentication. If y is entered to use the
mutual CHAP authentication, the following message appears. Enter the password of the CHAP
target.
# iSMiSCSISetup.sh
1) 0000000991000001
2) 0000000991000002
3) 0000000991000003
4) 0000000991000004
Please select serial number.
To use CHAP authentication, please enter ‘y’. [y/n]
Please enter the target CHAP secret.
Please enter password again.
To use mutual CHAP authentication, please enter ‘y’. [y/n]
Please enter the initiator secret.
To Next Page
Loading...
