NEC Storage M100 Series - Figure H-18: CHAP Authentication Tab in Iscsi Initiator Properties Screen

Release 6.0 415
User Guide Appendix H How to Set/Check Application Server (VMware) (iSCSI)
CHAP Parameter Settings
If CHAP authentication will not be used, this step is not necessary.
1. Click the CHAP Authentication tab in the iSCSI Initiator Properties screen.
 The default CHAP parameters are shown under the CHAP Authentication tab.
 To change these CHAP parameters, click the Configure button.
Figure H-18: CHAP Authentication Tab in iSCSI Initiator Properties Screen
For description of CHAP authentication, refer to Appendix N: "Retrieve Initiator
Information on Application Servers Registered with iSNS Server".