NEC Storage M100 Series - Using the Initialization Wizard to Modify the Configuration; Modifying the Disk Array Configuration; Figure 9-6: Message Asking Whether to Stop Monitoring; Table 9-2: Relation between the Initialization Wizard and Configuration Settings

Release 6.0 269
User Guide Chapter 9 Changes to the Configuration
9.3.2 Using the Initialization Wizard to Modify the Configuration
The configuration can be modified by re-running the initialization wizard.
The procedure is the same as the procedure for the first settings. For details of the procedure see,
Section 6.2.1: “Initialization Wizard”.
When you re-run the initialization wizard, NEC Storage Manager issues a message asking whether to
stop monitoring of the target disk array by NEC Storage Manager and to proceed with the initialization.
Click Yes and stop monitoring of the disk array to modify the configuration.
Figure 9-6: Message Asking Whether to Stop Monitoring
9.3.3 Modifying the Disk Array Configuration
Each setting configured by the initialization wizard can be modified individually.
See Table 9-2: Relation between the initialization wizard and configuration settings to find how the
settings configured in the initialization wizard and configuration settings are related.
Table 9-2: Relation between the initialization wizard and configuration settings
Setting in the initialization wizard How to modify the setting
Set Disk Array Subsystem Name Select Disk Array > Disk Array Management >
Change of Settings.
Time Settings Select Disk Array > Time Settings.
Setting host connection port parameters
(iSCSI)
Select Disk Array > Host Connection Port > Host
Connection Port Settings (iSCSI).
Setting iSNS server Select Disk Array > iSNS Server Settings.
License Unlock Select Disk Array > License Unlock.