Release 6.0 266
User Guide Chapter 9 Changes to the Configuration
9.2.2 Adding Application Servers
This section describes how to add logical disks and an application server to an initialized disk array.
1. Collect the host information on the application server
First of all, collect the host information on the application server to be newly added.
For details about collecting the host information of application servers, see Section 5.2: “Collecting
Host Information From Application Servers” or Section 7.2: “Collecting Host Information From
Application Servers”.
2. Retrieve the host information
Retrieve the host information of the application server.
Click Host > Host Operation > Host information collection on the menu located on the left of the
window to open the window for retrieving the host information.
3. Bind a pool
Bind a pool if logical disks should be bound not on an existing pool but on a pool that is newly
bound.
4. Bind logical disks
Bind logical disks to be assigned to the new application server.
Figure 9-3: Logical Disk Bind (FC)
Click Configuration, Logical Disk and Logical Disk Bind on the left pane of the window to start
binding the logical disks.
The rest of the procedure is the same as the procedure in Section 5.3.4: “Binding Logical Disks” or
Section 7.3.4: “Binding Logical Disks”.
To Next Page
Loading...
