NEC Storage M100 Series - Figure 3-17: AC Cable

Release 6.0 85
User Guide Chapter 3 Installing the Disk Array System
Connection Procedure
For AC Power Supply
1. Open the clamp part of the power supply cable clamp, set the power supply cable in the clamp and
lightly lock the clamp part.
2. Move the clamp part in the direction shown by the arrow below close to the lowest part of the plug
and then fix the clamp part steadily.
Figure 3-17: AC Cable
A loosely-locked clamp part may cause the power supply cable to come off.
Fix the power supply cable clamp steadily at a location close to the lowest part of the
power supply cable.