Release 6.0 410
User Guide Appendix H How to Set/Check Application Server (VMware) (iSCSI)
Connect the service console to an iSCSI network (only when with ESX Server 3)
After creating a VMKernel port for iSCSI Software Initiator, connect a service console with the same
vSwitch as for the target VMKernel port.
1. After logging in to the VI Client, select a server from the Inventory panel. This opens the Hardware
Configuration Page for this server.
2. Click the Network button for the configuration.
3. On the right side of the screen, click the Properties button for the vSwitch associated with the
created VMKernel port.
4. Click the Add button for the port.
5. After selecting Service console in the Connection Type screen of the Add Network Wizard, click
the Next button.
Figure H-10: Add Network Wizard Screen (4)
This operation is not required when using ESX Server 3i.
To Next Page
Loading...
