Release 6.0 140
User Guide Chapter 5 Initializing a Disk Array (FC)
Clicking OK applies the change of settings to the list.
When you click Next after changing the port settings as needed, the port settings are made.
Switch ID Specify the value of the switch for the port. The specifiable value range is
00h to 7dh.
When connecting multiple disk arrays in a loop topology FC switch
configuration, make sure that the value of each switch is unique.
Port type Select the port type.
Host port:
Select this when connecting to the host.
Data migration port:
Select this when using the data migration function.
Replication port:
Select this when using the remote data replication function.
This setting is displayed only when the data migration function and/or
remote data replication function is usable.
Parameter Description
When Replication port is selected for Port type, Platform cannot be
specified.
To Next Page
Loading...
