Release 6.0 151
User Guide Chapter 5 Initializing a Disk Array (FC)
Perform the following steps to bind a hot spare:
1. Select one or more physical disks for hot spare binding.
When you select the physical disks, pools with Enable Hot Spare are displayed in bold letters.
2. Click Set to display the following confirmation message.
3. Click Yes to perform hot spare binding.
Pool list Select a physical disk to create a hot spare.
When you select the physical disk for hot spare binding,
Enabled is displayed under the Enable Hot Spare field of
the Pool list. Pools that are enabled by a newly bound hot
spare are shown in bold.
Enable the copy back mode Select this option to enable copy back mode.
When a faulty disk is replaced by a new disk, copy back
mode automatically copies back the data to the new disk.
Parameter Description
For slots having no physical disks, the slot names and check boxes are
grayed out in the view display, and the slots are not listed in the list
display.
For physical disks for which a pool has been bound, the check boxes
are grayed out in the view display, and the disks are not listed in the list
display.
To Next Page
Loading...
