Release 6.0 391
User Guide Appendix F How to Set/Check Application Server (Linux) (iSCSI)
Setup method when using CHAP authentication of Initiator.
1. Use vi or another editor to open the /etc/iscsi/iscsid.conf file on the server.
2. After editing the file as shown below, save and close the file.
3. Restart the iSCSI service
Setup method when using bidirectional CHAP authentication.
1. Use vi or another editor to open the /etc/iscsi/iscsid.conf file on the server.
2. Edit the file as shown below, then save and close the file.
node.session.auth.authmethod = CHAP
node.session.auth.username = <iqn (username) of server>
node.session.auth.password = <password of CHAP Initiator>
(Example)
node.session.auth.authmethod = CHAP
node.session.auth.username = iqn.1991-05.com.microsoft.exp120rj
node.session.auth.password = jR021_0085sserpxE
# /etc/init.d/iscsi stop
# /etc/init.d/iscsi start
The CHAP Initiator password that is set here is a password that a target uses
to authenticate the Initiator. This password is also required for settings on the
disk array side (see Section: 15.3.21 iSMcfg setldsetchap in the NEC
Storage Manager Command Reference), so be sure to write it down so it is
not forgotten.
node.session.auth.authmethod = CHAP
node.session.auth.username = <iqn (username) of server>
node.session.auth.password = <password of CHAP Initiator>
node.session.auth.username_in= <iqn (username) of disk array>
node.session.auth.password_in = < password of CHAP target>
(Example)
node.session.auth.authmethod = CHAP
node.session.auth.username = iqn.1991-05.com.microsoft.exp120rj
node.session.auth.password = jR021_0085sserpxE
node.session.auth.username_in =
iqn.2001-03.jp.nec:storage01:ist-m000-sn-
0000000938209213.wn-0.target0000 -p 192.168.10.64:3260
node.session.auth.password_in = i3DegarotsiCEN
To Next Page
Loading...
