Release 6.0 42
User Guide Chapter 1 Overview
(5) Host port Host ports are used to connect hosts. The port
connector form, the number of ports and the
position of LEDs to show the status vary according
to the controller type.
(6) Disk port The disk port is used to connect to the next disk
enclosure. A controller has one disk port.
The port has a fault LED (below the port) and a link
LED (above the port).
(7) USB port These USB 2.0 ports are used for debugging. They
are not used under normal operation.
(8) Ejector The ejector is used to install and remove the
controller.
Label Description
To Next Page
Loading...
