: Default
BASIC SERVICE SETTING DATA
222 To complete the operation for setting Call Forwarding-All
Calls-Outside/Busy Line-Outside/No Answer-Outside
0
1
Setting when the station goes on
hook/when receiving Service Set
Tone (PBR time out)
Setting when receiving Service Set
Tone (PBR time out)
227 Whether the transferred C.O. call from station or attendant is
placed into queuing mode when all ACD/UCD stations are busy
NOTE: Effective only when CM08>212 is set to 1.
0
1
The call is placed into queueing mode
Recall to the transferring station when
the call is transferred from station, or
Attendant Camp-On is set when the
call is transferred from Attendant
228 Ringing start time for Wake Up call/Timed Reminder call 0
1
Start at preset time
Start at the time 5 minutes before pre-
set time
229 Choice of Night Service via DESKCON Programming Mode 0
1
Available
Not available
232 Trunk access from station in Room Cutoff status 0
1
Restricted to C.O. only
Restricted to all Trunk Route
233 Message Waiting lamp of calling station is extinguished when
an attendant answers
[8300R2]
0
1
Available See CM13 Y=13
Not available
234 Deletion of Call History-No Answer/Message Waiting irrespec-
tive of the station answering when calling back to Call History-
No Answer/Message Waiting
0
1
To delete
Not deleted
(To delete only when answering)
235 Deletion of all stored Call History-No Answer/Message Wait-
ing of calling station when answering the call
0
1
To delete
Not deleted
236 Special Dial Tone sending for Attendant Console or station dial-
ing a Message Waiting access Set/Cancel code
0
1
No tone
Tone is sent
237 Automatic Intercom to station set for Do Not Disturb 0
1
Restricted (ROT connection)
Allowed
238 Ringing of Manual Intercom call on station set for Do Not Dis-
turb
0
1
No ring
Ring on
Continued on next page
To Next Page
Loading...
