NEC Univerge SV8300 - [Cm05] Blade Type, Trunk Blade Number, Highway Channel for Isdn Data Communication

3-30 NWA-033623-001 Rev.8.1
91ch3001.fm
COMMAND CODE
TITLE:
BLADE TYPE, TRUNK BLADE NUMBER, HIGHWAY CHANNEL FOR
ISDN DATA COMMUNICATION
05
FUNCTION:
This command is used to designate the type of blade installed.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
DATA TABLE:
ST
++05Y
SLOT NUMBER
(4 digits)
+
DE
EXE
+
DATA
DE
(2-3 digits)
UNIT NUMBER
+
LINE/TRUNK CHASSIS NUMBER
(4 digits)
UNIT NUMBER
+
+
+
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING
DATA MEANING DATA MEANING
0 Blade Type XX ZZ XX : Unit No. (01-50)
ZZ : Slot No. (01-18)
See “About Unit
number, Slot number
and Circuit number”
10 Digital Line Circuit
Blade for Multiline
Terminal/DSS Console/
DESKCON
(CD-8DLCA/
CD-16DLCA)
20 Analog Line Circuit
Blade for Single Line
Telephone
(CD-4LCA/CD-8LCA)
21 LLC (OPX) Blade
(CD-4DIOPA)
30 C.O. Trunk Blade
(CD-4COTA/
CD-4COTB)
31 OD Trunk Blade
(CD-4ODTA)
Continued on next page
BLADE RESET
JULY/17/2009
CM05