NEC Univerge SV8300 - [Cm74] Stored Number for Station Speed Dialing

3-479 NWA-033623-001 Rev.8.1
91ch3005.fm
COMMAND CODE
TITLE:
STORED NUMBER FOR STATION SPEED DIALING
74
FUNCTION:
This command is used to enter the stored number for Station Speed Dialing feature into the memory al-
located with CM73.
PRECAUTION:
(1) Data can only be changed when the access code is displayed. Enter the data in the following order;
the new access code, comma, the called number, and . For clearing the data, enter “CCC”
and .
(2) When entering data with characters, the following characters can be registered;
Alphabet upper case (A-Z), alphabet lower case (a-z), numeric (0-9), symbol (! “ # $ % & ’ ( ) + ,
; < = > ? @ [ ] ^ _ ‘ { } ~), Space, hyphen (-), period (.), slash (/), colon (:)
NOTE: The character “CCC” cannot be registered.
ASSIGNMENT PROCEDURE:
EXE
EXE
ST
EXE++ +
+
74Y
DE
MEMORY SLOT NUMBER
(5 digits)
++
DE
STORED NUMBER
(Maximum 32 digits)
ST
EXE++ +
+
745
DE
++
DE
STORED NUMBER
MEMORY SLOT NUMBER
(5 digits)
(4 digits/1-8 digits)
CM74