Chapter 3 COMMAND DESCRIPTION
3-2 NWA-033623-001 Rev.8.1
91ch3001.fm
HOW TO READ THIS CHAPTER
HOW TO READ THIS CHAPTER
Information about each command is presented in the following order:
(1) FUNCTION: The function of the command.
(2) PRECAUTION: Precautions related to assigning data.
(3) ASSIGNMENT PROCEDURE: The procedure for assigning data in CAT mode.
(4) DATA TABLE: Detailed descriptions of the data.
In the description of each command, the following symbols are used.
: Default which is automatically loaded into the memory, after system reset by setting
position “A” on SENSE switch of the CPU, followed by a reset.
: Commands which require a reset of the CPU blade after data setting.
: Commands which can be used only under Off-Line mode of the CPU blade.
To set Off-Line mode,
(1) Set SENSE switch on the CPU blade to “E” or “F”.
(2) Press RESET switch on the CPU blade.
: Commands which require a reset of the blade by CME0 Y=3 after data setting.
: Commands which require a reset of the IPT (P2P CCIS) by CME0 Y=5>01 after data
setting.
You should confirm the meaning of default, and change or delete the data, if required.
HOW TO READ THIS CHAPTER
To Next Page
Loading...
