Chapter 2 PRECAUTION
2-6 NWA-033623-001 Rev.8.1
91ch2001.fm
METHOD OF SETTING ON-LINE/OFF-LINE MODE
METHOD OF SETTING ON-LINE/OFF-LINE MODE
FOR CPU BLADE
• Setting Off-line mode
(1) Set SENSE switch on the CPU blade to “E” or “F”.
(2) Press RESET switch on the CPU blade.
• Setting On-line mode
(1) Set SENSE switch on the CPU blade to “0-4”.
CPU will reset automatically after SENSE switch is set to “0-4”.
The conditions under off-line mode are as follows.
(1) All stations are not available when this setting is made (only the station call via PFT connection
is available).
(2) All trunks are not available when this setting is made.
(3) PCPro can be connected by either IP connection or RS-232 connection.
(4) IP connection is available only for PCPro (IP connection is not available for SMDR and OAI).
(5) RUN LED under on-line mode is a repeat of Lights (950 ms.) OFF (64 ms.).
APRIL/16/2010
To Next Page
Loading...
