NEC Univerge SV8300 - [Cm60] Att Tenant Group, Functions

3-435 NWA-033623-001 Rev.8.1
91ch3005.fm
COMMAND CODE
TITLE:
ATT TENANT GROUP, FUNCTIONS
60
FUNCTION:
This command is used to assign a number to a Desk Console for access on a tenant basis, and define the
consoles’ night switching ability, off-hook ringing, tone ringer, password code for Attendant Lockout
and Attendant Programming.
[8300R2]
PRECAUTION:
(1) After setting CM60 Y=00, 01, 02, 04, 06, 16, 17, 22, 23, 27, 30, 51, DESKCON soft reset by CM60
Y=90>0: 0 is required.
(2) When assigning a password code for DESKCON by CM60 Y=30, the Function number (0/1) is
required as the first data. The purpose of Function numbers is shown below.
0: To assign a password for Attendant Lockout
1: To assign a password for Attendant Programming the following features:
Remote Access to System (DISA), System Speed Dialing, Date and Time, Choice of Night
Service and Tone Ringer
ASSIGNMENT PROCEDURE:
+ 60YY + +
DESKCON
++ +
NUMBER
DATA
(0-7)
EXE
ST
DEDE
FUNCTION
NUMBER
(0/1)
(1-8 digits)
+ 6030 + + + + +
DATA
EXE
ST
DEDE
FUNCTION
NUMBER
(0/1)
(1-8 digits)
+ 6090 + + + + +
DATA
EXE
ST
DEDE
FUNCTION
NUMBER
(0)
(0)
NOVEMBER/12/2008
CM60