Chapter 2 PRECAUTION
2-11 NWA-033623-001 Rev.8.1
91ch2001.fm
NATION CODE ASSIGNMENT
NATION CODE ASSIGNMENT
With the Nation Code assigned, the system offers the particular services to the users of each country.
For Australia or New Zealand, appropriate nation code to the user should be assigned by CM31 Y=0 as
shown below.
• Users in Australia
• Users in New Zealand
NOTE 1: System reset is required after changing the command data.
NOTE 2: Default of CM31 Y=0>0 depends on each nation code of the CPU program as follows:
For Australia/NZ : 01
For North America : 03
For Asia/Africa/Europe/Latin America/Middle East/Russia : 04
NOTE 3: In case of EU, the default of CM31 Y=0>0 is same as North America (nation code 03).
Therefore, you must set the nation code to 05 by this command.
+ 310 + + 0 + + 01 +
EXE
ST DEDE
+ 310 + + 0 + + 15 +
EXE
ST DEDE
JANUARY/14/2011
To Next Page
Loading...
