NEC Univerge SV8300 - [Cm08] Basic Services

3-33 NWA-033623-001 Rev.8.1
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICES
08
FUNCTION:
This command is used to assign basic features on a system wide basis.
PRECAUTION:
After setting 1st data 335, 391, 420, 592, 909, system reset is required.
ASSIGNMENT PROCEDURE:
DATA TABLE:
BASIC SERVICE: 011-096
+08+ +
BASIC SERVICE
++ +
FEATURE
DATA (0/1)
(3/4 digits)
EXE
ST
DEDE
(1 digit)
: Default
BASIC SERVICE SETTING DATA
011 Operator Monitoring
[Australia Only]
[8300R2]
0
1
Not available
Available
012 Attendant Override/Busy Verification
[8300R2]
0
1
Not available
Available
014 Attendant Loop Release
[8300R2]
0
1
Available
Not available
018 Attendant Night Transfer
[8300R2]
0
1
Not available
Available
See CM51 Y=13
026 Group Diversion 0
1
Available
See CM16 Y=2 CM19 Y=6
Not available
028 C.O. to C.O. transfer by station or attendant
NOTE: This data is effective for C.O. trunks (Ground Start/
Loop Start) which receive a release signal from the
C.O.
0
1
To allow
Not allowed
029 When tandem call duration passes a predetermined time, the
call is disconnected or continued
(Related Command: CM35 Y=119, CM41 Y=0>54)
0
1
To disconnect
To continue
Continued on next page
JANUARY/31/2012
CM08