NEC Univerge SV8300 - System Data Memory Partial Clear

3-5 NWA-033623-001 Rev.8.1
91ch3001.fm
COMMAND CODE
TITLE:
SYSTEM DATA MEMORY PARTIAL CLEAR
01
FUNCTION:
This command is used to clear the data for specific features.
PRECAUTION:
This command can only be used in off-line mode.
ASSIGNMENT PROCEDURE:
DATA TABLE:
OFF LINE
ST
EXE
++ ++01
DE
CLEAR DESIGNATION
(2/3 digits)
++
DE
CCC
CLEAR DESIGNATION SYSTEM DATA TO BE CLEARED REMARKS
08 CM08: Basic Service
20 CM20: Numbering Plan/Single Digit Feature Access Code
CM21: Single Digit Access Code
CM22: Route Advance
CM23: Tenant Development
CM25: Kind of Special Terminal Development
CM29: Numbering Plan Tenant Group
2A CM2A: ID Code Assignment with CPU/Development Block Number
Assignment for Each Calling Party Number
76 CM76: Digit Conversion on DID Call
770 CM77: Station Name Assignment To clear only for the
station memory of
CM77 Y=0, 1, 4, 5
85 CM85: Maximum Number of Sending Digits
8A CM8A: LCR/Toll Restriction Development Table
8B CM8B: Toll Restriction pattern number for Call Forwarding-Outside
[8300R6]
JULY/15/2011
CM01