NEC Univerge SV8300 - System Data Memory All Clear;Sram Clear

3-3 NWA-033623-001 Rev.8.1
91ch3001.fm
COMMAND CODE
TITLE:
SYSTEM DATA MEMORY ALL CLEAR/SRAM
CLEAR
00
FUNCTION:
This command is used to confirm that system data memory (RAM) area billing memory area (SRAM)
can be written-in/read-out, and to assign the default to the RAM area or SRAM area.
PRECAUTION:
(1) This command can only be used in off-line mode.
(2) When this command is executed, “OK” is displayed with memory clear completed (about 10
seconds later).
(3) If an error exists in memory, “WD ERROR” is displayed.
(4) This command is not available with a CAT.
To clear all system data, set SENSE switch on the CPU blade accommodated in Unit01 to “A”, and
depress RESET switch on the CPU blade accommodate in Unit01. In this case, the only functional
port is Physical Port No. 010101 or Virtual Port No. 0000, which is assigned as a CAT.
(5) The SRAM area data which is cleared by CM00>02,10,11 is as follows.
ASSIGNMENT PROCEDURE:
OFF LINE
:Cleared data
SRAM AREA DATA
1ST DATA
RELATED COMMAND
02 10 11
Fault Information  ––
OAI FLF Memory  ––
Roaming Backup Memory  ––
Billing Memory –
VRS built-in CPU (Voice Data)  –  CM04 Y=01>12,
CM08>896
Call Charge Output to SMDR  –  CM04 Y=01>12
Other SRAM Area Data  ––
+00+ +
MEMORY AREA
++ +
DESIGNATION
CCC
(1/2digit)
EXE
ST
DEDE
APRIL/16/2010
CM00