NEC Univerge SV8300 - [Cm12] Station Class-1

3-156 NWA-033623-001 Rev.8.1
91ch3002.fm
COMMAND CODE
TITLE:
STATION CLASS-1
12
FUNCTION:
The features for each station are determined by assigning Station Class-1 to each station number.
PRECAUTION:
(1) When assigning Station Class-1 to Multiline Terminal by this command, enter
“X-XXXXXXXX (My Line number)” of FX-FXXXXXXXX, which is assigned by CM10 Y=00,
as the first data.
Also when assigning to IP Station, enter “X-XXXXXXXX (IP station number)” of
FX-FXXXXXXXX, which is assigned by CM10 Y=01, as the first data.
(2) The data for Single Line station number, My Line number of Multiline Terminal, Virtual Line
station number, Automatic/Manual/Dial Intercom number, Loop Line number and ICI/OPR Line
number, IP station number are shown in the table on next page.
(3) The table below shows the key layout for Line/Trunk/Feature Keys and One Touch Keys of the
Multiline Terminals.
LINEXX: Line/Trunk/Feature Key
DSS : One Touch Key
Continued on next page
CM12 Y=24: 7 (A mode) CM12 Y=24: 0 (B mode)
DT330/
DT730
(12D)
Same as CM12 Y=24: 7 (A mode)
DT330/
DT730
(12D)+
8LK
Same as CM12 Y=24: 7 (A mode)
LINE01 LINE02 LINE03 LINE04 LINE05 LINE06
LINE07 LINE08 LINE09 LINE10 LINE11 LINE12
LINE01 LINE02 LINE03 LINE04 LINE05 LINE06
LINE07 LINE08 LINE09 LINE10 LINE11 LINE12
DSS
DSS
DSS
DSS
DSS
DSS
DSS
DSS
JANUARY/14/2011
CM12