NEC Univerge SV8300 - [CME6] CALL FORWARDING SET;RESET from Pcpro;Cat

3-655 NWA-033623-001 Rev.8.1
91ch3008.fm
COMMAND CODE
TITLE:
CALL FORWARDING SET/RESET FROM PCPro/CAT
E6
FUNCTION:
This command is used to set/reset Call Forwarding service to each station from a PCPro/CAT.
PRECAUTION:
CME6 can be used for any station irrespective of its state.
ASSIGNMENT PROCEDURE:
DATA TABLE:
NOTE: To reset the Call Forwarding, assign “CCC” to the second data.
Continued on next page
CCC
+
ST + +E6YY EXE+
(for reset)
DE
STATION No.
(1-8 digits)
+
DE
DESTINATION No.
(1-31 digits)
+
: Default
Y MEANING DESTINATION
00 Call Forwarding-All Calls • Destination=Extension;
X-XXXXXXXX: Station No. (1-8 digits)
• Destination=Outside party;
X-XXXX + + YY...YY
X-XXXX: Outgoing Trunk/LCR Group Access Code (1-4 digits)
: Separate Mark
YY...YY : Called No. (Maximum 26 digits)
• Destination=Attendant; E000
[8300R2]
NONE
: No data
01 Call Forwarding-Busy Line
02 Call Forwarding-No Answer
03 Call Forwarding-Busy Line/No
Answer
04 Split Call Forwarding-All Calls 0: Destination for Split Call Forwarding (Block 0)/ATT
1: Destination for Split Call Forwarding (Block 1)
2: Destination for Split Call Forwarding (Block 2)
3: Destination for Split Call Forwarding (Block 3)
4: Destination for Split Call Forwarding (Block 4)
5: Destination for Split Call Forwarding (Block 5)
6: Destination for Split Call Forwarding (Block 6)
7: Destination for Split Call Forwarding (Block 7)
8: Destination for Call Forwarding
9: Destination for Station Speed Dialing (Block 0)
NONE
: No data
05 Split Call Forwarding-Busy Line/No
Answer
,
,
See
CM78
NOVEMBER/12/2008
CME6