: Default
Y MEANING DESTINATION
06 Call Forwarding-PS Out of Cell
(Zone) Standard SIP station
• Destination=Extension;
X-XXXXXXXX: Station No. (1-8 digits)
• Destination=Outside party;
X-XXXX + + YY...YY
X-XXXX: Outgoing Trunk Access Code (1-4 digits)
: Separate Mark
YY...YY : Called No. (Maximum 26 digits)
• Destination=Attendant; E000
[8300R2]
NONE
: No data
Call Forwarding-Logout (IP Station)
Call Forwarding-Not Available
(Standard SIP station)
07 Timing of Call Forwarding-No
Answer for a trunk incoming call on
a station basis
001: 1 second
120: 120 seconds
NONE
: As per CM41 Y=0>100
08 Timing of Call Forwarding-No
Answer for an internal call or an
assisted call on a station basis
001: 0-4 seconds
(4 seconds increments)
120: 116-120 seconds
NONE
: As per CM41 Y=0>101
50 Mobile phone number link up with a
Mobility Access station number
XX...XX: Mobile phone No. (Maximum 26 digits)
(X: 1-9, A (*))
NONE
: No data
NOTE 1: Station number cannot be assigned to second data.
NOTE 2: When the mobile phone number has been already assigned to other station number, “ASSIGNED
ALREADY” is displayed.
NOTE 3: Outgoing Trunk Access Code (1-4 digits) must be assigned by CM64 Y=10/14/15/16.
NOTE 4: When the system operates both CME6 Y=50 and CME6 Y=51, set the same number of the 2nd data of
CME6 Y=51 as the 2nd data.
51 Destination of ISDN Alternative
Routing of in Remote Unit survival
mode (station basis)
• Destination C.O. line number (Maximum 26 digits)
NONE
: No data
NOTE 1: When the system operates both CME6 Y=50 and CME6 Y=51, set the same number of the 2nd data of
CME6 Y=50 as the 2nd data.
NOTE 2: When 2nd data of CM64 Y=12 is set to “0”, the destination is set by this command.
To Next Page
Loading...
